Celestial Being's action stand

Has purchased this action stand time ago, just really lazy to spray it due to the problem of masking. Till last week, after I finish my Char's Zaku 2, I was forced to start it. I need to "return" Char's action stand to my MG Char's Zaku 2 ^^

Here show some masking steps.

Step 1, I didnt spray surfacer for the base. I direct masking for those to be remain on white colour part. Actually is a mistake. W/o surfacer, the colour cannot really stick on the plastic, they can easily drop off if you accidently rub it.

Step 2, I spray 1st layer, blue colour.

Step 3, mask the blue colour parts.

Step 4, Spray yellow colour. (Here I missed a step, actually I spray white surfacer before yellow, as yellow covering not so good, I scare if directly spray yellow on blue, the colour might not be nice)

Step 5, few steps photo been missed out again =___=" first, I tear off all the masking tape, then mask the outter part which I no need for the deep blue colour, then spray enamal colour, deep blue. After that, use zippo thinner to rub off unwanted enamal deep blue colour. Below photo, top right part's deep blue enamal colour still not yet rub off.

Done!!!!

Another photo with my MG Exia ^^V

MG MS06S Char Zaku II ver2

Have finished this days ago, just the Char's stand was occupied by Exia. Have to finish Exia's stand first then only can help my "re-born" Zaku snap some photos ^^